One push press (1) Mold face fairy features jumpstart your project

Description

We have an extended handling time currently. No handling charge though.
Title:
this is a mold of a 1.5 inch very beautiful fairy face female.
The mold is ooak handcrafted and it is taken from one of my carvings
lOSTinart ebay store
See examples of what my organic face molds look like. That are non-flexible
T
he face that comes from this mold is 1.5inches from top to bottom
.
Please note that the face molds (unless otherwise stated) are hard to use for a beginner.
Although I have seen some beginners do just fine after a few tries. I make faces which
are flatter with less 3-d features. But then when the crevices and face form detail is
lessened to make it easier for the beginner, many of the details are taken out also.
This face is a level 7 on the the difficulty scale, 1 being the easiest and 10 being
most difficult.
You are purchasing a one of a kind mold from a one of a kind face sculpture done by myself.
You
may not reproduce a mold from the positive (face form) that comes from the mold. You may not
sell molds to the face form that comes from the mold. You are purchasing the right to incorporate
this face form into your own art. If you sell on your own site please do not advertise that the face
is your own original design. This causes confusion to other artists that see mine and then see that
you are calling it your own original. It is handmade by you but not your original design.
HOW TO USE THE FACE MOLD: place the empty mold in the freezer for 10 minutes.
Prepare your polymer clay by kneading it, folding it over as this conditions the clay.
Have the clay you are going to push into the mold softened. only after 10 minutes of
sitting in your freezer, take the organic polymer clay mold out of the freezer and brush
in baby powder with cornstarch (it works the best) into the mold. I sort of flatten the
polymer clay (i prefer premo) but most work great and then push one side into the
mold, holding the clay with the other hand so the clay does not rock back and forth
or move at all while taking the impression. You must really push into the deepest
part of the mold to get the tip of the mold. If you do not push your clay deep into the
crevices enough, the end of the nose will be flat, or the eyes will not be as detailed,
nor will the lips be defined. RECOMMENDED CLAYS ARE POLYMER CLAY, fIMO, PREMO,
KATO, SCULPEY III,  KERNIT, PAPER MACHE CLAY, COLD PORCELAIN,  ANY TYPE OF
CLAY THAT CAN BE PUSHED INTO THE MOLD, HOLD FORM WHEN TAKEN OUT AND
THEN BAKED.
DO NOT BAKE YOUR FIGURAL WHILE IN THE MOLD.
FOR MAKING YOUR
OWN JEWELRY, GLUE ONTO BOXES OR USE FOR  MIXED MEDIA WALL ART, YOU WILL
BE ABLE TO USE THIS MOLD OVER AND OVER AGAIN FOR MANY DIFFERENT PROJECTS.
DO NOT USE SOAP, DO NOT USE POURED RESINS OR MOLTEN METALS, iF YOU ARE
UNSURE PLEASE ASK
Auction Template ©2005
Templates By Endearah